Fix Finder
What’s the problem?
Household
55 fixes
Why does my irrigation pump lose pressure after running for 30 minutes?
Your irrigation pump likely loses pressure after 30 minutes because the well screen is clogged, the pump is overheating, or the pressure…
See the fix
Why does my irrigation pump VFD keep tripping on overload?
Your irrigation pump VFD is probably tripping overload because the pump is jammed or worn, the motor is drawing too many amps,…
See the fix
Why does my livestock barn's ventilation system use so much power?
Your barn's ventilation system probably uses too much power because the fans are dirty, the belts are loose, or the thermostat is…
See the fix
Why does my variable frequency drive on the irrigation pump keep tripping
A VFD trips when it detects overcurrent, overheating, ground faults, or input voltage issues — often caused by worn pump bearings, clogged…
See the fix
Why does my well pump cycle on and off every few minutes
Your well pump short-cycles because the pressure tank's air charge is low, the pressure switch is misadjusted, or a leak lets pressure…
See the fix
Why does my well pump keep short-cycling and how do I fix it?
Your well pump short-cycles because the pressure tank is waterlogged, the pressure switch is misadjusted, or a leak in the system drops…
See the fix
why does my well pump keep turning on and off every few minutes
Your well pump is short-cycling because the pressure tank's air charge is low or the pressure switch is misadjusted, causing the pump…
See the fix
Why does my well pump short cycle every 2 minutes
A well pump that short cycles every two minutes usually means the pressure tank has lost its air charge or the pressure…
See the fix
Why is my center pivot irrigation system losing pressure and stalling?
A center pivot losing pressure and stalling usually means a clogged nozzle, worn pump impeller, leaking pipe joint, or a failing pressure…
See the fix
Why is my center pivot irrigation system stalling
Your center pivot usually stalls because one of its safety switches tripped, often from low water pressure, a misaligned tower, or a…
See the fix
Why is my center pivot irrigation system stalling and how do I fix it?
A center pivot stalls most often because of low water pressure, clogged nozzles, or a faulty pressure switch that shuts the system…
See the fix
Why is my center pivot irrigation system stalling at the same spot every cycle?
A center pivot that stalls at the same spot usually has a stuck microswitch, worn drive motor, or misaligned tower alignment sensor…
See the fix