Fix Finder
What’s the problem?
Household
78 fixes
Why do the lights flicker in our warehouse whenever the large motors start?
Voltage drops from large motor inrush current cause momentary flickering; this indicates undersized wiring, weak supply, or excessive motor starting current. Installing…
See the fixWhy do warehouse lights flicker when large motors start up?
Warehouse lights flicker when large motors start because the sudden inrush current drops voltage across the shared circuit, causing momentary dimming. This…
See the fixWhy does equipment keep overheating on the shop floor?
Equipment on the shop floor usually overheats because air can't get to it, the room is too hot, or the machine is…
See the fixWhy does my equipment keep tripping the circuit breaker?
Equipment trips breakers when it draws more current than the circuit can handle, usually due to overloaded circuits, faulty wiring, motor startup…
See the fixWhy does our 3-phase motor trip the breaker every time it starts?
A 3-phase motor trips the breaker on startup because the inrush current exceeds the breaker's instantaneous trip setting, often due to an…
See the fixWhy does our air compressor keep tripping the breaker when it starts up
Your air compressor likely trips the breaker on startup because its motor draws 5-7 times normal current for a few seconds, overwhelming…
See the fixWhy does our air compressor keep tripping the circuit breaker?
Your air compressor trips the breaker because it draws a high inrush current on startup that exceeds the breaker's rating, or the…
See the fixwhy does our air compressor trip the breaker every morning at startup
Your air compressor trips the breaker at startup because the motor's inrush current — often 5-7 times normal running amps — exceeds…
See the fixWhy does our CNC machine keep tripping the 20-amp breaker?
The breaker trips because the CNC machine draws more than 20 amps during startup or heavy cuts, possibly due to motor inrush…
See the fixWhy does our CNC machine trip the 200A breaker every morning at startup
Your CNC machine likely trips the 200A breaker at startup because its motor draws 6-8 times normal current during inrush, exceeding the…
See the fixWhy does our CNC machine trip the breaker every time it starts up
Your CNC machine likely draws a massive inrush current at startup that exceeds the breaker's instantaneous trip threshold, especially if the breaker…
See the fixWhy does our commercial building have a high power factor surcharge on the electric bill?
A high power factor surcharge means your equipment draws more reactive power than your utility allows, usually from motors, transformers, or old…
See the fix











