Why is my cold storage facility using 30% more electricity than last year?
Your cold storage facility's electricity spike likely comes from refrigerant leaks, failing compressor valves, degraded door seals, or defrost cycles running too…
See the fixFix Library
Practical, step-by-step fixes for warehouse & facility energy problems — 66 published so far.
Your cold storage facility's electricity spike likely comes from refrigerant leaks, failing compressor valves, degraded door seals, or defrost cycles running too…
See the fixYour cold storage facility is using more power than budgeted usually because of air leaking through door seals, evaporator fans running nonstop,…
See the fixYour cold storage facility's bill is likely higher because refrigeration systems run longer when door seals leak, evaporator coils frost over, or…
See the fixYour cold storage facility is likely using more power than budgeted because of frost on the evaporator coils, worn or open door…
See the fixYour cold storage is using more power than budgeted mostly because of excessive door openings, frost buildup on evaporator coils, worn door…
See the fixYour demand charge is higher because your facility draws a lot of power in short bursts — like starting large motors or…
See the fixDemand charges are billed on your highest 15-minute power draw during the month, not on total kilowatt-hours used. If your facility starts…
See the fixYour warehouse lighting bill is likely higher than expected because you're using outdated fixtures, leaving lights on when the space is empty,…
See the fixHigh lighting bills in a warehouse usually come from outdated fixtures, inefficient bulbs, or lights left on in unoccupied areas. Check your…
See the fixYour warehouse lighting bill is likely higher because you're using old fluorescent or metal halide fixtures that waste energy, or your lights…
See the fixYour LED high-bay lighting bill stays high because the fixtures likely run at full power 24/7 without occupancy sensors, daylight harvesting, or…
See the fixYour LED high-bays may be drawing more power than expected due to incorrect drivers, poor power factor, or controls that keep them…
See the fix